SQUARE D GENERAL DUTY SAFETY SWITCH 400 A 240 VAC/V~ CATALOG NO. D325NR SERIES: E01 AMPS/A: 400A FREQUENCY: 50/60HZ

SQUARE D GENERAL DUTY SAFETY SWITCH 400 A 240 VAC/V~ CATALOG NO. D325NR SERIES: E01 AMPS/A: 400A FREQUENCY: 50/60HZ TYPE: 3 ENCLOSURE RAINPROOF SINGLE THROW FUSABLE WITH SOLID NEUTRAL HP RATING VOLT 240 VAC/V~ PH. 3 STD. 50 MAX. 125 NOT FOR USE AS MOTOR CONTROLLER FOR MOTORS OVER 100 HORSEPOWER USE MOTOR STARTER LUGS SUITABLE FOR 75 DEG. C. CU/AL CONDUCTORS TORQUE MAIN LUG MOUNTING HARDWARE TO 175 LB.IN. THE STARTING CURRENT OF MOTORS OF MORE THAN THE STANDARD HORSEPOWER RATING MAY REQUIRE THE USE OF FUSES WITH APPROPIATE TIME DELAY CHARACTERISTICS CONTINOUS LOAD CURRENT NOT TO EX CEED 80% OF THE RATING OF FUSES EMPLOYED IN OTHER THAN MOTOR CIRCUITS TO MODIFY SWITCH FOR USE WITH CLASS R FUSES ONLY ORDER KKIT NO. DRK40 AND INSTALL PER INSTRUCTIONS TO CONVERT THE SWITCH FOR USE WITH CLASS J FUSE REMOVE FUSE BASE AND REPOSITION TO HOLES NEAREST THE SWITCH BASE (NOTE: SEE MARKING IN BACK OF ENCLOSURE FOR LOCATION) TORQUE BASE MOUNTING SCREWS TO 50 LB.IN. OIL MECHANISM BEARING SURFACES (NOT CURRENT CARRYING PARTS) ANNUALLY WHEN USED FOR CLASS H OR CLASS K FUSES THIS SWITCH IS SUITABLE FOR USE ON A CIRCUIT CAPABLE OF DELIVERING NOT MORE THAN 10,000 RMS SYMMETYRICAL A 240 VAC MAXIMUM USE OF RENEWABLE FUSES IN THIS SWITCH IS NOT RECOMMENDED SUITABLE FOR USE AS SERVICE EQUIMENT LOG TORQUE REQUIREMENTS LINE LOAD AND NEUTRAL LUGS WIRE SIZE (2) 1/0 AWG - 250KCMIL TORQUE LB.IN.340 SERVICE GROUND LUG WIRE SIZE 1-4/0 AWG TORQUE LB.IN.180 FOR CONDUIT ENTRY ABOVE CURRENT CARRYING OR LIVE PARTS USE UL LISTED RAINTIGHT OR LIQUIDTIGHT HUBS FOR CONDUIT ENTRY USE ONE OF THE FOLLOWING SQUARE D CONDUIT HUBS CONDUIT 3" CATALOG NO. B-300 OR H-300 CONDUIT 3 ½" CATALOG NO. B-350 OR H-350 CONDUIT 4" CATALOG NO. B-400 OR H-450 ACCESSORIES EQUIPMENT GROUNDING KIT PKOGTA2 (2 REQUIRED) CLASS R FUSE KIT DRK40 DATE CODE 200901 UL LISTED ENCLOSED SWITCH ISSUE NO. AL-40 40262-035-08.